EasyPro Vortex Solids Filter with Medium Aquafalls Kit

This solids filter will greatly reduce cleaning of any waterfall filter box!
Cleaning the filter pads at the bottom of any waterfall filter is hard and dirty work. Left undone,
the pads plug and the water goes around the pad unfiltered back to the pond. The Vortex Solids Filter
(VSF) is a prefilter that removes a majority of these solids from the water prior to the waterfall filter where
biological filtration occurs.

How it works:
Incoming water enters the VSF at a slight downward angle. The heavier solids
are pushed to the outside and directed towards the bottom by the grooves in the
outer wall. A drain port makes for easy cleaning of the solids that accumulate in
the cone shaped sediment area at the bottom of the filter. The water then flows
through a filter pad at the top of the filter (where it is easier to clean). After the
fine solids are taken out, the water then flows via gravity out thru three air entrainment
ducts, which enrich the water with oxygen.

•  The Vortex Solids Filter should sit within 4' of the waterfall filter

•  Maximum flow rate is 4500 GPH

•  Measures 36" high by 23" in diameter at base

•  Greatly improves waterfall filters performance by reducing solids and improving oxygen levels

Vortex Solids Filter and Water fall Filter Package:
The VSF can be purchased in a package with the Pro-Series Medium AquaFalls Waterfall Filter
(AM). Which includes three 2" bulkheads installed in the back wall of the AquaFalls instead of a
2" on each side. All fittings are included. All piping between VSF and AM is done outside the filter
box so no cutting of filter pads in needed.

Package includes all plumbing and fittings needed for installation except for three pieces
of 2" pipe (rigid or flex) for use between filter and VSF. Length needed will depend on distance
between filters.

Ships Motor Freight